剪切模量是幂函数的成层土的地震随机反应

基于改进的一维剪切梁模型，对剪切模量是其深度的某一幂函数的成层非均质土层，得到其稳态动力响应的封闭型解析表达式。首次证明了这种土层振型函数的正交性，然后利用随机振动理论，并基于基岩输入地震加速度的功率谱密度函数：白噪声谱和过滤白噪声谱。研究了该土层对地震的随机动力响应问题。计算结果表明，1)在基岩输入地震加速度的功率谱为白噪声谱的情况下，土层的最大期望反应均有别于过滤白噪声谱时的相应值；2)平稳输入与输出过高地估计了土层的随机响应。     

玻璃纤维增强聚氨酯泡沫塑料的压缩力学性能研究

本文研究了两种不同密度的玻璃纤维增强聚氨酯泡沫塑料在准静态压缩下的力学性能。给出了与相应密度的普通泡沫塑料力学性能的比较，实验结果表明：两种增强泡沫塑料在压缩载荷作用下，具有不同于普通泡沫塑料的应力－应变特性，压缩模量和强度一般均有不同程度的提高，而且对相同纤维含量的增强泡沫塑料来说，密度较高的材料增强效果较好。     

界面特性对短纤维金属基复合材料蠕变行为的影响

基于短纤维增强金属基复合材料(MMC)的单纤维三维模型(三相)，利用粘弹性有限元分析方法对影响金属基复合材料的蠕变行为的因素进行了较为系统的分析。研究中主要讨论了界面特性和纤维取向角对金属基复合材料的蠕变性能的影响。研究结果发现，界面特性诸如厚度、模量和应力指数都对纤维最大轴应力和稳定蠕变率产生影响：稳态蠕变率随界面模量的增大而逐渐减小，当高于基体模量时基本保持不变；纤维轴应力的变化与蠕变率正好相反。稳态蠕变率随界面厚度、应力指数的增加而增大；而轴应力则随之减小。同时不同的纤维取向也影响金属基复合材料蠕变时的轴应力分布和稳态蠕变率。     

碳纤维布与钢板复合加固梁剥离破坏研究

通过12根碳纤维布与钢板复合加固钢筋混凝土梁的抗弯性能研究,结果表明复合加固方式能有效地改善被加固构件的受力性能,但常由于复合加固层的剥离可能导致加固效果的降低。复合加固层与被加固构件之间的剥离是由于薄弱截面在剪应力及正应力的集中作用下而产生的,文中对复合加固层与混凝土之间的粘结剪应力及剥离正应力的计算公式分别进行推导,并进一步对碳纤维布与钢板复合加固的剥离机理进行分析,为工程应用提供依据。     

Several contributions to soil compactibility induced by cyclic loading test

To investigate the soil compactibility during the cyclic loading, three different kinds of paddy field soils were prepared so as to clarify interrelationships among stress amplitude ratio, bulk density, soil water content and pore water pressure. The presetting values of specimen include the soil water content(percent dry basis) and bulk density of 25% d.b. and 1.1 Mg/m³ respectively. The relation between the number of cyclic loading and axial strain exhibited an asymptotically increasing trend, converging toward a specific value for each experimental condition. Possible effect caused by elastic–plastic characteristics could be recognized, when axial strain for 0.5 Hz excitation becomes greater than the one of 1.0 Hz under same stress amplitude ratio. When the stress amplitude ratio took 0.1, the absolute value of axial strain of 0.5 Hz was greater than the one of 1.0 Hz, whereas its decreasing trend was recognized in the sequence of silt, clay and silty sand. The qualitative relations between pore water pressure and number of cyclic loading were also examined to scrutinize the effect of effective water pressure to the soil compactibility.     

皖中膨胀土的承载比(CBR)强度特性研究

针对皖中地区高速公路建设中遇到的膨胀土问题,选取合六叶高速公路典型土样开展了系统的承载比（CBR）特性试验研究,并在此基础上探讨了膨胀土作为路基填料的适用性。研究表明:（1）起始含水量对膨胀土CBR值影响显著,CBR最大值对应的含水量高于最佳含水量,且击实功越大,二者差值也越大;（2）CBR膨胀量随起始含水量增大而减小,起始含水量越低,CBR膨胀量就越大,路基的水稳性就越差;（3）当击实功较大时,膨胀土的最佳含水量较小,适合填筑的可变含水量范围较宽,建议现场施工控制采用重型击实标准;（4）在重型击实条件下,将弱膨胀土起始含水量控制在比最优含水量大2%⁴%范围内,能同时满足压实度和CBR值要求以用于填筑下路堤,中膨胀土作为路基填料时必须经过改性处理。研究结果对于在膨胀土地区进行公路建设具有参考意义。     

循环载荷下砂质土的本构模型

提出了一个描述砂质土循环载荷条件下主要特性的本构模型，并且采用不同围压下多种加载途径的土力学实验确定了模型中的待定材料常数，由本构模型的增量工数值积分计算所得到的理论曲线与不同应力路径下实验曲线十分接近，经实验验证这种本构模型能广泛地应用土工问题的弹－塑性有限元分析中。     

Rheology/morphology/flow conditions relationships for polymethylmethacrylate/rubber blend

Viscoelastic behavior, phase morphology and flow conditions relationships in polymer/rubber blends have been investigated. The importance of such correlations is illustrated on polymethylmethacrylate (PMMA)/rubber blends subjected to different flow conditions both under small and large deformations. In small-amplitude oscillatory shear (the morphology does not change during the flow) the elastic modulus G of the concentrated blends shows a secondary plateau, G _p , in the low frequency region. This solid-like behavior appears for rubber particle contents beyond the percolation threshold concentration (15%). Morphological observations revealed that for concentrations higher than 15%, the particles are dispersed in a three-dimensional network-type structure.In capillary flow it was found that the network-type structure was destroyed and replaced by an alignment of particles in the flow direction. This morphological modification resulted in a decrease in both viscosity and post-extrusion swell of the blends. Morphological observations revealed that the ordered structure in the flow direction was concentrated only in the skin region of the extrudate, where the shear stress is higher than the secondary plateau, G _p . A simple kinetic mechanism is proposed to explain the observed morphology.Similarly, steady shear measurements performed in the cone-and-plate geometry revealed alignment of particles in the flow direction for shear stress values higher than G_p.Presented in part at the Symposium Recent Developments in Structured Continua Montréal (Canada) 26–28 May 1993 and at the 45th Canadian Chemical Engineering Conference, Quebec, October 15–18 (1995)     

爆炸荷载作用下钢筋混凝土梁的动力响应及破坏形态分析

对基于Timoshenko梁理论建立的非线性动力有限元法作了改进。根据压区理论得到混凝土的平均剪应力和平均剪应变关系,建立了能反映箍筋的抗剪作用的材料模型;此外,对结构在爆炸荷载作用下可能出现的各种响应现象进行了描述,以准确地预测梁破坏时不同位置截面上钢筋和混凝土的受力、变形及破坏情况。应用改进的材料模型,对爆炸荷载作用下的五个钢筋混凝土试验梁的动力响应和破坏形态进行了数值模拟,结果表明,该数值方法能较好地模拟钢筋混凝土梁的弯曲、弯剪和剪切等破坏形态。     

钢筋混凝土轴心受压构件的非线性稳定性

采用我国混凝土规范GB50010-2002规定的混凝土应力一应变关系,考虑混凝土强度、构件长细比及混凝土徐变,从构件的非线性理论出发对钢筋混凝土轴心受压构件的承载力进行了研究,给出了混凝土构件临界状态时的构件边缘应变和纵向弯曲系数的计算公式。研究表明,徐变对轴心受压构件的承载力有很大影响。当不考虑混凝土徐变时,按本文公...